AVR10 engelsk 11/01/98 10:10 Side 4
Front Panel Controls
1. POWER BUTTON5.BALANCE CONTROL11. TUNE / PRESET 14. SEEK STEREO BUTTON
ENGLISH
Press this button to turn the powerThis control is used for balancing theUP/DOWN BUTTONSPress this button, OAuto� will
on. Press again to turn the power offrelative sound volume of the left andWhen PRESET and AUTO is not lit,illuminate in the display. Then press
(Stand by). If you connect the otherright channel speakers. Clockwisethe Tune/Preset UP/DOWN buttonsthe uP or DOWN button. The tuner
components to the switched outlet, itrotation reduces the volume from thewill allow you to tune to a stationwill automatically seek for stations
can also be used as a system powerleft speaker, counterclockwisemanually.upwards or downwards in your area
button.rotation reduces the volume from thethat have enough signal strength to
12. TUNE / PRESET BUTTON
right speaker.be listenable. The tuner will stop on
2. HEADPHONE JACKPress this Tune/Preset button to lightstations until the Seek Stereo button
Stereo headphones can be plugged6. SURROUND up the preset mode then use theis pressed again.
into this jack for private listening.MODE SELECTORup/down buttons (11) momentarily to
Headphone impedance should bePress this button to select the desiredscan the preset station frequencies.15. VOLUME CONTROL
between 8 ohms and 2K ohms withsurround mode. The mode isThe receiver stops at each presetTurn the VOLUME clockwise to
best results between 200 and 400changed between normal DOLBYlocation from 1-30 that has beenincrease the volume and
ohms.Pro-Logic and DOLBY 3-STEREO.entered in memory. Hold the buttonscounterclockwise to decrease it. The
(11) down to skip through the presetsvolume of the front, center, and rear
3. BASS CONTROL7. BYPASS SELECTORquickly. In the TUNE mode (selectedchannels is changed at the same
Modifies the low-frequency sound ofDefeats all surround modes.by the TUNE/PRESET button (12))time.
the left and right channels as much aspress these buttons to change
8. INPUT FUNCTION
?10dB. Set this control at a suitableselected frequencies.16. DISPLAY WINDOW
SELECTOR BUTTONS
position for your taste and roomThis window shows the state of
acoustics.Press these buttons to select the13. MEMORY BUTTONoperation for easier control of the
desired input source.Use this button to store an AM or FMreceiver. It also contains the IR
4. TREBLE CONTROLfrequency. Press this button andRemote Sensor.
Modifies the high-frequency sound of9. TAPE MONITOR BUTTONselect one of 30 preset locations to
the left and right channels as much asPress this button to select input fromstore the frequency with the UP /
?10dB. Set this control at a suitablea tape deck and listen to its monitorDOWN buttons while the memory
position for your taste and roomfunction (with 3 head decks).indicator blinks, press MEMORY
acoustics.again to store preset station.
10. VCR2 INPUT JACKS
NOTE: When you store a frequency in
Connect these jacks to the
a memory location that already
corresponding output jacks of a VCR
contains a frequency, you replace the
or Camcorder (only playback)
previous frequency. If your receiver is
(Yellow: Video, Red/White: Audio).
disconnected from AC power for
more than about 2 weeks, it loses all
stored frequencies.
4 |